Reinstalled - puter says the Edge 705 was not ejected proper

Please report any problems with this Forum, or make suggestions for improvement

Reinstalled - puter says the Edge 705 was not ejected proper

Postby garryr on Fri Jun 11, 2010 1:02 am

Morning, guys

This might be a general problem or specific to me.

I had a puter freeze (rare) but the original Ascent program disappeared. The blokes at Montebello (nice people) gave me the code and I was up and running again.

Now, when I ask the Edge to synch with the program, I get a message that the Edge was not correctly ejected last time. I make a point of properly ejecting but I admit I might have been at fault.

The point is that I now cannot pass data to the Edge.

A solution is urgently sought.

Thanks

garryr
garryr
 
Posts: 3
Joined: Thu Nov 20, 2008 10:50 am

Return to Forum Issues

Who is online

Users browsing this forum: No registered users and 1 guest

cron